+ Post New Thread
Threads 1 to 30 of 30

Forum: DIY Section

Tips on DIY ideas

  1. Looking for a boiler

    Spending me PPI befor i got it looking to get a new Combie Boiler,no idear about them really . Had a ferroli here for ten years no probs,think its...

    Started by plasterer‎, 21-08-2013 23:40
    • Replies: 9
    • Views: 56,272
    23-08-2013 21:22 Go to last post
  2. Tiling advice

    I've just fitted new worktops in my kitchen however I don't think the splashback tiles match and I'd like to buy some Mosaic tiles, the area is less...

    Started by deeboi‎, 02-08-2011 14:13
    2 Pages
    1 2
    • Replies: 14
    • Views: 476
    10-08-2011 13:21 Go to last post
  3. Fluoresent Tube

    I'm needing a new fluoresent tube for my kitchen, the one I have taken out is an L58 (5ft) and I want to put in a 65w tube instead of the 58w one. ...

    Started by deeboi‎, 23-12-2010 12:30
    • Replies: 2
    • Views: 208
    23-12-2010 22:12 Go to last post
  4. Concrete Mix

    Had a good day here today and dug a hole for a scaffolding pole to be cemented into for my motorized sat dish to go on. Everywhere I look the info...

    Started by deeboi‎, 01-04-2010 16:55
    concrete, mix
    • Replies: 3
    • Views: 191
    05-05-2010 15:47 Go to last post
  5. Cooker Cable

    I have just sold my cooker and foolishly unwired it from the wall, leaving the wire on the cooker. DOH!!!! I have some leftover twin & earth...

    Started by deeboi‎, 10-02-2010 15:06
    cable, cooker
    • Replies: 2
    • Views: 252
    10-02-2010 15:56 Go to last post
  6. Radiators

    I've got a slight problem with my radiators, lived here over a year now and Its always been like this. The upstairs radiators are roasting hot and...

    Started by deeboi‎, 11-11-2009 08:48
    2 Pages
    1 2
    radiators
    • Replies: 10
    • Views: 749
    05-12-2009 00:51 Go to last post
  7. Plumbing and Heating

    Alright guys I'm a Plumber so if you need advice dont hesitate.

    Started by wiz569‎, 29-05-2008 22:23
    2 Pages
    1 2
    heating, plumbing
    • Replies: 15
    • Views: 1,072
    04-12-2009 23:41 Go to last post
  8. electrical query

    Just had a whole RCD trip on me. Flicked it back and all is ok, question really is what makes the RCD trip rather than an individual circuit like...

    Started by marvious‎, 08-10-2009 07:27
    2 Pages
    1 2
    electrical, query
    • Replies: 10
    • Views: 685
    27-10-2009 12:48 Go to last post
  9. My Job Description

    My job is so fucking unbelievable. I'll try to sum it up by first telling you about the folks I work with: First, there is this supermodel...

    Started by plasterer‎, 14-08-2009 00:09
    description, job
    • Replies: 2
    • Views: 447
    14-08-2009 21:19 Go to last post
  10. Attic Ceiling

    We have a converted attic with a dormer. I have removed the old plasterboard ceiling as it was all over the place. I plan to clean up the joists in...

    Started by marvious‎, 03-07-2008 15:23
    2 Pages
    1 2
    attic, ceiling
    • Replies: 11
    • Views: 1,121
    12-08-2009 11:41 Go to last post
  11. Gas fire cuts out

    As above It runs for a hour or so then cuts off If we put the Boiler on with the fire It cuts off Any Idears.............Paul

    Started by plasterer‎, 12-05-2009 22:12
    cuts, fire, gas
    • Replies: 3
    • Views: 602
    13-05-2009 00:17 Go to last post
  12. Chipped Enamel Bath

    I've got a steel enameled bath and the other day it just flexed and some of the enamel flaked off revealing a bit of the steel. I'm trying to get...

    Started by marvious‎, 03-04-2009 12:34
    bath, chipped, enamel
    • Replies: 8
    • Views: 668
    04-04-2009 15:47 Go to last post
  13. Phone Sockets

    Right I know I'm not supposed to do this but does anyone know how to wire in a BT master socket, mine (ahem) fell off. Thanks

    Started by marvious‎, 05-03-2009 09:54
    phone, sockets
    • Replies: 4
    • Views: 615
    05-03-2009 13:02 Go to last post
  14. firebird firepac 70-90

    this goes out to any plumbers who can help i have the above burner but i pissin through oil with it im not even getting 2 months for 500l now there...

    Started by glic83‎, 17-02-2009 18:51
    7090, firebird, firepac
    • Replies: 5
    • Views: 544
    20-02-2009 23:05 Go to last post
  15. FAO Wiz or any other plumber.

    Got a plumbing question for ya m8. I moved house a few months ago and finally getting round to doing the minging bottom toilet. As you can see...

    Started by deeboi‎, 25-01-2009 18:16
    2 Pages
    1 2
    fao, plumber, wiz
    • Replies: 12
    • Views: 996
    05-02-2009 23:26 Go to last post
  16. copyright removal of DVD

    Hi all, Anyone knows how to remove copyright from DVD to enable me copy a DVD for a friend. Cheers

    Started by Babakolly‎, 04-02-2009 01:24
    copyright, dvd, removal
    • Replies: 2
    • Views: 485
    04-02-2009 12:13 Go to last post
  17. Post Painter & decorator

    Hi painter from Dundee, Scotland, anyone need any help, tips, or anything else let me know, I'm here to help. :thx:

    Started by kevink8453‎, 04-01-2009 13:17
    decerator, decorator, painter
    • Replies: 0
    • Views: 519
    04-01-2009 13:17 Go to last post
  18. Angry Faulty Teka dishwasher Model No-UN DW640FI

    The dishwasher was running fine until i ran it after removing the top drawer to fit in some large plates. It stoped half way through the cycle. When...

    Started by gavshell800‎, 29-12-2008 15:20
    dishwasher, dw640fi, faulty, model, noun, teka
    • Replies: 2
    • Views: 712
    29-12-2008 16:05 Go to last post
  19. Manchester - Recommended Tradesmen (or women)

    Well I hope this thread is ok. I'd like to start off a recommendation thread for any good companies or individuals for all sorts of work as it is...

    Started by marvious‎, 27-05-2008 12:57
    manchester, recommended, tradesmen, women
    • Replies: 5
    • Views: 723
    25-12-2008 14:19 Go to last post
  20. Filling the gaps between paving slabs

    My garden is paved and when the council done it they left loads, well moslty gaps between the paving stones and I get loads of weeds/grass growing up...

    Started by deeboi‎, 07-07-2008 21:21
    filling, gaps, paving, slabs
    • Replies: 8
    • Views: 891
    16-12-2008 21:38 Go to last post
  21. granite sink

    I have a granite kitchen sink,does anybody know of the best way to clean it??

    Started by dave68‎, 08-11-2008 12:32
    granite, sink
    • Replies: 4
    • Views: 675
    14-12-2008 18:03 Go to last post
  22. Thumbs up Xbox 360 - PS3 controller mod

    Good god this looks awsome. Gonna have to stock up and have a go at this baby myself!! Ever wanted to use a 360 pad on a PS3?? Personally i cant...

    Started by leeb1977‎, 01-12-2008 15:38
    360, controller, mod, ps3, xbox
    • Replies: 1
    • Views: 574
    01-12-2008 15:44 Go to last post
  23. Reanult Spares?

    Sort of DIY related - anyone know the best place for car spares? it's for a 1997 Renault Scenic - i need a coil pack ( common problem apparently!) ...

    Started by ManofScience‎, 13-06-2008 09:59
    2 Pages
    1 2
    reanult, spares
    • Replies: 10
    • Views: 1,197
    28-11-2008 23:03 Go to last post
  24. Plastering

    well some bodys Got to start it off Any Body needs Plastering tips ,Am your Man Dont be scared to ask ...................Paul

    Started by plasterer‎, 27-05-2008 12:19
    3 Pages
    1 2 3
    plastering
    • Replies: 20
    • Views: 2,375
    28-11-2008 23:02 Go to last post
  25. baxi 80 combi boiler

    i have a problem with a combi boiler i found that the pressure switch was faulty so i shorted it out and the heating worked fine i also got hot water...

    Started by pickle‎, 26-10-2008 09:00
    baxi, boiler, combi
    • Replies: 3
    • Views: 650
    03-11-2008 09:06 Go to last post
  26. Plasterboard

    We have just put up a plasterboard ceiling with square edge and now are looking at the jointing. Can someone let me know what's best (probably...

    Started by marvious‎, 30-08-2008 12:20
    2 Pages
    1 2
    plasterboard
    • Replies: 10
    • Views: 1,187
    01-09-2008 21:01 Go to last post
  27. Wee project I've been working on

    This is a bench I made for my daughter using nothing but the old top part of a bunk bed. I wish I took step by step photo's now but you'll get the...

    Started by deeboi‎, 20-06-2008 18:12
    project, wee, working
    • Replies: 8
    • Views: 977
    14-07-2008 20:46 Go to last post
  28. Electrical Help

    Hello guys im a sparky in the Bristol area my main work is on three phase and machine controls, motor curcuits etc i have done many rewires to latest...

    Started by pickle‎, 27-05-2008 19:20
    electrical
    • Replies: 6
    • Views: 794
    29-05-2008 23:03 Go to last post
  29. Building Work

    If anyone needs advice on building work I may be able to help, can't answer every question, but I'll certainly try.

    Started by Will‎, 29-05-2008 14:17
    building, work
    • Replies: 0
    • Views: 603
    29-05-2008 14:17 Go to last post
  30. Painting & decorating

    hi im a painter & decorator in the st helens area. if you need any of my sevices or advice contact me..

    Started by saints1‎, 28-05-2008 15:31
    decorating, painting
    • Replies: 1
    • Views: 613
    29-05-2008 01:28 Go to last post

+ Post New Thread

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts